Description: Building Compiz on a Raspberry Pi.
Author: admin
Categories: Robotics
Created: 2023-11-19 02:55:59
Modified: 2023-11-19 02:55:59
Description: Essential Anet A8 Upgrades. Adding Mosfets, Increasing Voltage to Power Supply, Marlin.
Created: 2023-11-15 07:53:04
Modified: 2019-05-20 11:55:30
Description: How to Setup the Raspberry Pi with a Touch Screen.
Description: How to use the RN-42 Bluetooth Module with Arduino to Send/Recieve Data, HID Profiles, and settings.
Description: How to Build an AC Electrical Outlet that you can shut turn on and off via WiFi using an ESP8266.
Description: Using the Arduino Autonomous Ground Vehicle. PID Control, Setting Speeds, Proportions, Obstacle Avoidance, Sensor Data, and GPIO.
Description: Using the Robot Library to navigate environments and avoid obstacles. PID Control, Sensor Data, GPIO Library, and more.
Description: Using the C++ Serial Library. Configuring Baudrate, Blocking/Non-Blocking, Setting Attributes, and Interactive Mode.
Description: How to use the Simple G-Code Sender to send G-Code via USB Serial. Will be using a Raspberry Pi or Linux Computer.
Description: Configuring Marlin and Flashing Firmware, Boot Loader, Settings Speeds.
Description: This Will show you how to align and calibrate your Z-Offset for 3D Printers.
Description: This is a guide to set up Marlin Firmware for 3D Printers.
Modified: 2023-09-07 14:42:38
I wanted to become an artist because it meant endless possibilities. Art was a way of reinventing myself.